Circular saw blade holder

3267 Views 6 Replies 6 Participants Last post by old55, Mar 15, 2021

jemangin

Discussion Starter · Mar 14, 2021

Saw this on utube,

. Added a french cleat so I could put it out of the way when not needed. When I want to change a blade I can bring the whole thing to the saw. If you buy another blade, you can just add another slot to the end of it.

See less See more

Save

Reactions: 1

1 - 7 of 7 Posts

old55

· #2 · Mar 14, 2021

Good idea. Thanks.

Save

DesertRatTom

· #3 · Mar 14, 2021

Be careful reaching over that thing. I did something like that for my Work Sharp workstation to hold the glass disks. The bar holds them in place just in case. I love the red knobs, painted with Ferrari Red fingernail polish. Many of my shop cabinets have bright red knobs.

See less See more

Save

Reactions: 1

mgmine

· #4 · Mar 14, 2021

I just skip the wood and drive a nail in a post. I then hang the blades using the hole in the center. I doubt that it matters but it keeps the edges safe by not sitting on wood for years at a time until I finally need the blade. Yours looks much nicer though!

Save