Router Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
:moil:
Hi one and all,
As a new participant to this forum, I would like to express my gratitude as to it`s existance.
I`m sure that I will get answers to the questions that have been dogging me here in Australia.
Here are some of the queries about the CNC Shark Plus Pro :-
Is there a supplier in the States who can supply all of the following items as one bundled package freighted to Brisbane Queensland Australia at a reasonable cost to the buyer?
[A] Can I buy this CNC machine, configured for 240 volts, direct from the States ready for use in Australia?
Instead of being fitted with the Bosch Palm Router, can this router be replaced at the initial buy time with a DeWalt DW611 240 volt router?
[C] Can a Kent/CNC split shoe be supplied at the initial buy time?
[D] Can four{4} Rockler CNC 2 1/4 inch rails plus eight{8} slide shoe washers to suit, be also supplied to strengthen the CNC platform table for extra rigidity?
[E] Router bits 1/4 inch shank -
[1]four fluted Ball Nose !/4 inch x 2
[2] " " " " 1/8 " x 2
[3]Two " End Mill 1/4 " x 2
[4] " " " " 1/2 " X 2
Any help in this regard would be truly appreciated.
Regards, Leighton.
 

·
Registered
Joined
·
15 Posts
Hi leighton
Did you get any of the info you were looking for?

I have started into cnc in Brisbane, may be we could talk about usefull suppliers.
PM me.

Bez
 
1 - 2 of 2 Posts
Top