Router Forums banner
1 - 1 of 1 Posts

· Registered
51 Posts
Discussion Starter · #1 ·
i have a partially finished cnc router that i want to hire someone to install limit switches, wire from smooth stepper board to motor driver's then to
stepper motor's.configure to mach3 or g-sender, i have them both installed. connect spindle control to smooth stepper board. ensure power supplies are
correctly connected. anyone in 150 miles of southern minnesota, north iowa, get a hold of me. i could deliver it and leave for a month?
ken @ 507-383-4392. ps i am using v-carve pro and have a AXIOM router that i am using now. i like the design and save file to thumb drive, then
just plug in to pendant to run the project.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.