Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I am trying to find an exploded view of the Z axis on a CNCEST 6040 as the linerar bearings in the axis fell to bits I have bought new ones however would like to check the setup of the assembly especially the lower bearing on the lead screw and nut. I am going to add a thrust bearing to the top of the screw under the stepper motor, All help would be appreciated.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top