Router Forums banner
1 - 1 of 3 Posts

· Registered
30 Posts
Burrs on the metal of the collet or shank of the cutter. File or sand them smooth to make it work better. But not too much or they won't clamp right.

sandy022 said:
i have a makita-3612c in table mount and both quarter inch and half inch
bits are very hard to get out of the router,can someone tell me what
causes this to happen
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.