Lawrence:

If you take the collet all the way off, you'll see 4 gripping fingers. The outside of those fingers are tapered, the inside should be 1/4" diameter cylindrical. If you stick a 1/4" bit in the collet with it off the router, you should see that the inside fits tight against the shaft of the bit the entire distance through.


Tom

 

The ID of the collet should be straight throughout it's length. The OD should be tapered. It sounds like your collet may be sprung. Does the bit fit properly on the opposite end?

 

Hi

It sounds like user error, the collet nut on the Colt is a one part thing so to say,try this take the nut off the Colt put the bit in the nut and then put it back on the router,,,make sure the shank of the bit is sticking out of the nut when they are new it can be hard to break it in..

====

 

Thanks

Wow, thanks everyone for the quick and helpful replies. I am going to put these suggestions to the test tonight.

Lawrence

 

Lawrence: I have one of those Colts. It works great except for the spindle lock. That is what the smaller wrench is for. There are 2 flats on the spindle the smaller wrench fits it. The larger one of course is for the collet nut. I have tried tightening it using the spindle lock but have bits creap on me.

 

Every Bosch tool comes with a card that says: "If you experience any problems with your Bosch tool please call 1-877-BOSCH99."

 

Thanks

Thanks Mike. I usually go to forums like this before I brave the cold dark world of customer service but I appreciate the tip. Cheers.

 

Lawrence, I remember how frustrating it can be when you start down the road of woodworking. I used a little known secret method for improving my skills... I read the owners manual start to finish. Being a typical guy I was astonished to find that someone had taken the time to expain everything about a tool or assembly of a project. I went on to discover that there were woodworking plans which told you the order to perform the various operations which when followed sometimes resulted in success. Even for me, the guy who could hammer in three nails and only bend two of them. The point of my ramblings is don't get discouraged. We all start out the same way. Read your tool manuals and the "Sticky" threads at the top of each section of the forums. They are all loaded with good information.

 

I hear what you say Mike, I hear what you say.

 

I know this is an old thread, but I'm experiencing pretty much the same thing as the OP posted. When I purchased this router and put a bit in for the first time the bit flew out. Now I can't really get a bit into the collet at all. When I try the bit does seem to be wonky and not perpendicular and straight as I think it should be. Any advice? Thank you!

 

the collet is not completely releasing...
call Bosch CS... you'll be glad you did...
I don't know what to tell you otherwise because I've never run into this any of mine...

after thought... do have an imported bit that isn't a true ¼'' shank???
did you clean the collet and the bit's shank???

Router Forums - Router and Woodworking Discussion Community
Router Forums - Router and Woodworking Discussion Community
Router Forums - Router and Woodworking Discussion Community