Router Forums banner
1 - 1 of 6 Posts

· Registered
7,196 Posts
The biggest issue I see is that the 1/4 shank isn't particularly strong, so you will at least want to make a lot of very shallow passes to make the full cut.
All I use is 1/4" shanks. Normally rout 1/2" plywood, but yes, do take shallow cuts, AND often rout very slowly. Slow and shallow has kept me out of having router problems lo these many years.
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.