Finally completed the hall table for wife. This is the first time I glued up Walnut and had a slight "cup" in the finished board. When I used the round over bit in the router, I did not have a reveal in the middle of the board on both ends. The cup was about 1/16", so I clamped a 2x4 about 1 foot from the end to flatten the top. I ran though the router table again was able to get the reveal I wanted. The cup was not bad as you cannot see it unless you lay a straight edge across the board. Top is 14" deep and 48" long. Wife already has it loaded with "stuff".
Frank
Frank
Attachments
-
723.2 KB Views: 218
-
816 KB Views: 163