Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
159 Posts
Discussion Starter · #1 ·
I will be demonstrating live on March 7th 12 noon ET how to make a compression mold (using a router) to veneer a OG profile on a radius table edge. This will be a good one. Register HERE
This will be a taste of what my upcoming article will be on in American Woodturner - Veneering a turned object and what I will be teaching at Marc Adams School of Woodworking in October.
I hope to see you then.
Scott Grove
397912
397915
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top