Router Forums banner
1 - 1 of 13 Posts

· Retired Moderator
16,386 Posts
I use a push block to keep pieces square and steady when needed. Like Marc Summerfeld does in some of his videos. If I need to I drill a hole in the push block big enough to get the jaw of an F clamp into. Cost= $0 because I use scrap that I would have burned anyway, plus the push block gives blow out protection at the end of the cut.
1 - 1 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.