Router Forums banner

corect direction

1489 Views 1 Reply 2 Participants Last post by  Mike
New at table routing and want to know by diagram the direction to to go both on the outside and inside of a piece. Thanks for any help.

1 - 2 of 2 Posts
Bob, you will find this answer in many posts with a full explanation of why. To make a long story short: When table mounted you will pass your work in front of the bit from right to left or clockwise.(When on the outside) Reverse this for inside or if you are free hand routing.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.