This is a good place to try PowerTool.ManualsOnline.com - We found it so you don't have to! I don't know if they have it, however, the directions should be very similar to many of the others shown. Also, I am wondering if you wold tell us where you are living, Paul, It and Enjoy the Router Forums, There is a lot of great information here. Enjoy

 

Welcome to the RouterForums Paul.

 

I too have this jig #315.25710. Don't know if it's complete or how to use. Wouls like the manual if anyone has it. Manuals Online does not.

 

This may help

Router Forums - View Single Post - Craftsman Dovetail Fixture Kit #2576
Router Forums - View Single Post - introduction

=====

 

Hi Paul, welcome to the forum
You said "jig". Is this a router, dovetail jig, what??? If you can, post a picture. Someone will likely recognize it and be able to help you set it up.

 

I recognize this is an old thread - but I have the manual for 315.25710 Sears Craftsman Dovetail Template. I can PDF it to those in need.

 

I have the 315.25710 but need a manual.

 

Welcome DJ. If you use our Community Search to look that up it comes up quite a few times.This post I copied a link to may help some as some of the others might also. http://www.routerforums.com/jigs-fixtures/27095-craftsman-dovetail-jig-315-25710-a.html

 

The instructions for setting up most dovetail jigs are the same. Some clamp the boards with levers while others use knobs. Positioning your wood is pretty much universal with a fixed template dovetail jig. I uploaded the Woodstock dovetail jig manual to our Router Reference section under specialty items here:

http://www.routerforums.com/other-s...ecialty/71226-woodstock-dovetail-jig-will-help-set-up-most-jigs.html#post726082

 

If someone still needs this manual (315.25710 Sears Craftsman Dovetail Template) - PM me with your email address and I will forward a PDF copy.

 

stevesie

ref: craftsman dovetail template manual 315.25710
I do need a copy of this manual if you still have it in pdf.

Thanks
Chip cedarboats@yahoo.co

 

@stevesie

Steve, you can send me the PDF in an email by clicking on my name in any post. I will make sure it gets loaded into the right place on the forums.