Router Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I read an article on the forum that described my problem exactly. I use mine exactly the same way. Upside down in a router table, where the switch is left on and the router table switch turns the router on. When I switched it to a plunge router it quit. I followed the instructions given on the forum and removed the switch and cleaned it. It still didn't work. So I removed the switch again, and carefully took it apart. I found clumps of sawdust, and the points were burnt. I used and old diamond deb nail file and filed the points flat, installed it and that solved the problem and run again. I ordered another switch right away.
Try it . it works.
 

·
Official Greeter
Joined
·
18,811 Posts
G’day Rich

Welcome to the router forum.

Thank you for joining us
 

·
Registered
Joined
·
10,671 Posts
Greetings and welcome to the router forum. Thank you for joining us, and remember to have fun, build well and above all be safe.
 
1 - 3 of 3 Posts
Top