Router Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
16 Posts
The collet is part of the shaft and cannot be replaced. I have a similar router. I rarely use it and have it mounted horizontally . My router only takes 1/4" shaft cutters. If the cutter slips I do not know of a remedy. You may have to trash it as a cutter that slips is dangerous besides ruining the work.
mike
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top