Router Forums banner
1 - 1 of 1 Posts

· Registered
Paul
Joined
·
2,175 Posts
I think that on some old Craftsman routers the inner part of the collet was the motor shaft. There are several manuals available here, maybe look up your model and see if that's the case. Don't forget to pull the bit out a little (maybe 1/8") before tightening. A bottomed-out bit can cause tightening issues.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top