[KhalTom]

Anybody have any ideas on where I can find a pulley guard for my Craftsmen Table Saw? It's part#60252 if that helps. Any idea where I can go?

Sent from my SM-G955U using Tapatalk

 

[Stick486]

what is the entire model number of your TS???
if this one you may have to fabricate something from say light gauge sheet metal....
http://www.routerforums.com/tools-w...n-113-table-saw-pulley-guard.html#post1561578

found this...
https://www.terapeak.com/worth/sears-craftsman-table-saw-113-belt-guard-60252/281885189576/

 

[KhalTom]

Model 113.298750 is the model. From what I understand it was a one year model, harder to find than most. On fact on the Sears part page it doesn't even list that model #... Show a 113.298751 which I'm guessing is the same.

Sent from my SM-G955U using Tapatalk

 

[Cherryville Chuck]

Tom just build an out feed table over it and you don't need it. Once you'used the saw with an out feed table you won't want to do without it. I just finished taking one that was 3 1/2' wide off and replacing it with a 4' wide so that when I rip plywood sheets I don't have to hold the ends down when it's all the way through.

 

[JIMMIEM]

Anybody have any ideas on where I can find a pulley guard for my Craftsmen Table Saw? It's part#60252 if that helps. Any idea where I can go?

Sent from my SM-G955U using Tapatalk

I have the part. PM me with your name and address and I will mail it to you.

 

[KhalTom]

Thank you!!! Pm sent

Sent from my SM-G955U using Tapatalk

 

[RÖENTGEEP]

I have the part. PM me with your name and address and I will mail it to you.

I love this in this great forum.:smile: