Router Forums banner

Craftsmen 113 Table Saw Pulley Guard

1958 Views 6 Replies 5 Participants Last post by  RÖENTGEEP
Anybody have any ideas on where I can find a pulley guard for my Craftsmen Table Saw? It's part#60252 if that helps. Any idea where I can go?

Sent from my SM-G955U using Tapatalk
1 - 1 of 7 Posts
Tom just build an out feed table over it and you don't need it. Once you'used the saw with an out feed table you won't want to do without it. I just finished taking one that was 3 1/2' wide off and replacing it with a 4' wide so that when I rip plywood sheets I don't have to hold the ends down when it's all the way through.
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.