Router Forums banner
1 - 1 of 8 Posts

· Retired Moderator
16,386 Posts
That's nice and clean Tom. Was the hole in front of the blade for an "exacti-cut"? I remember that as a feature on some Sears saws. In regard to your other thread about the insert plate, it looks like there might be enough of a recess where your insert goes that you could use set screws to do the leveling. You would need a minimum of 1/8" deep, 3/16 would be better.
1 - 1 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.