This is a cutting board I made for my daughter. It is made of Rocky Mountain Ash and African Cherry. The keepers on the ends are biscuited to the main lamination. I have been trying to route a dovetail mortise and through tennon but when I was told this was easier I tried it. It is much easier!
I used my router table and a bottom bit to form the drawer pull on the ends. The router bit is just showing above table top when I drop the board down and slide it to the stop. Then I raised the bit slowly to the desired dept. I avoided a possible mess had the bit been at full extension and then dropped the board into the bit.
I used my router table and a bottom bit to form the drawer pull on the ends. The router bit is just showing above table top when I drop the board down and slide it to the stop. Then I raised the bit slowly to the desired dept. I avoided a possible mess had the bit been at full extension and then dropped the board into the bit.
Attachments
-
193.3 KB Views: 340