Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
Hey everyone,

I'm trying to make a 8" Hexagon and a 6" Hexagon jig. I have tried a few times but they never come out like Ricks did. What size of board do I have to start out with for both and is 22.5 degrees the right angle to cut. I'm cutting them on a 10" chop saw. Any help would be greatly apprenciated.

Thank you in advanced

:confused: CANMIL
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top