Cutting sinkhole into kitchen counter

13030 Views 4 Replies 5 Participants Last post by bobj3, Oct 23, 2006

Saw Dust

Discussion Starter · Sep 17, 2006

Any advise on cutting a sinkhole in a post form countertop? What is the best bit? What about using a template, or free-hand? Is the router the best tool to use or should I go with a jig saw? Thanks for replying.

Save

1 - 1 of 5 Posts

TRosell14843

· #3 · Oct 21, 2006

I pushed the blade too often and I am not happy with the hole. I mounted and under mount sink so I will probbaly go with a router to finish it tight to the bowl with a guided bit that will guide on the bowl below. Havent done it yet because you only get one chance to do it right. When I do I will post. Good luck

Save

1 - 1 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.