Router Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
132 Posts
Discussion Starter · #1 · (Edited)
Are Hitachi M12V alterations possible

I have a Hitachi M12V router mounted in a router table.I would like to make an attempt at building some raised panel doors. I am in possession of a set of Freud 3 1/2" raised panel bits.It appears to me that some modifications to the router base is required before I attempt to use this set of bits. Is there a modified base available or should/can the existing router base be altered to accomodate my set of bits?

Thank you in advance for any advice on this matter.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top