Router Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
60 Posts
Discussion Starter · #1 ·
I just saw where Jessem is about to release a new version of their dedicated table motor. I saw a lot of bad reviews on the old version so hopefully the new design will be better. I do like the idea that this one has fresh air inlet hoses and the controls are all remote!! Although I wonder if the hoses would be in the way of my lift.....

Only problem is it only comes in a 4.2" diameter which won't fit my new lift........

Anyone know of any other similar setups that have 3.5" diameters?
 

· Registered
Joined
·
22,917 Posts
A few years ago a member (Stick), suggested a way to keep the sawdust out of a table mounted router. He suggested running a snorkle, or tube wrapped around the base of the router (top), that allows filtered or at least relatively clean air. I went with a Triton for the table. Built in lift, yeah! but it also pushes air out past the bit so it keeps sawdust at bay. Dust collection is a bit deal for health. I have seen a few people drill extra holes in their plates and tables so the under table box pulls it away. A behind the fence dust port is also helpful and I always brush away sawdust from the last cut so it doesn't affect the cut on the next piece.
 
1 - 2 of 2 Posts
Top