Router Forums banner
1 - 20 of 32 Posts

·
Registered
Joined
·
1,064 Posts
Very nice!!
I need to do some more 3D carvings.
 

·
Registered
Joined
·
192 Posts
Discussion Starter · #8 ·
If you don't mind sharing, what tool are you using on the finish pass and how much step-over?
Finish pass tool is 1.0mm tapered ball, the stepover is 0.2mm
This is probably over kill. Advantage is it does excellent detail and a smooth finish with minimal post sanding. The down side is long run time.
 

·
Registered
Joined
·
31,264 Posts
better than very nice...
 

·
Administrator
David
Joined
·
3,978 Posts
No, I am currently CAD illiterate. I purchase STL files online at ebay, etsy anywhere I can find what I need.
That doesn't take away from the work, not at all. I was just curious.

Do you run dust collection the entire job or just occasionally vacuum the dust/shavings?

David
 

·
Registered
Mike
Joined
·
3,841 Posts
Dan That is a nice clean carve. It will look good on the wall.
 

·
Registered
Joined
·
855 Posts
I find it hard to fathom... running a router for thirteen hours straight. I wouldn't think it would last very long with those run times. Just amazing. Beautiful job!
 
1 - 20 of 32 Posts
Top