Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
I am no expert, but I have had a similar problem with mu Delta Band Saw when I do not allow the saw to take the lead and cut at it's own rate of speed. Sometimefs I get "antsie" then push the work and the blade will (especually when it is 1/8") deflect and push into the back of the center.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top