Router Forums banner
1 - 20 of 23 Posts

·
Registered
Joined
·
1,002 Posts
Discussion Starter · #1 ·
I have drawn up a sketch up of my design but I don't have sketch up pro can I post here?
 

·
Registered
Joined
·
31,264 Posts
Herb says it's okay...

go for it...
 

·
Registered
Theo
Joined
·
7,182 Posts
I'm with Stick. If Herb says it's OK, it's good.
 

·
Registered
Joined
·
1,002 Posts
Discussion Starter · #10 ·
Well here goes not much space in room its going in. So desk is going to be tall 6 ft. Also taking a page from Mikes build of his bench using the solid wood panels. I''m going to use 3 20 " by 6 ft these will be the up right pieces. The right bottom will have a door not in plans yet. Also a keyboard tray under bottom shelf on left mounted on 2 drawer slides also not on drawings.


Here are 2 sketch ups one has dimension the other just drawing.
 

Attachments

·
Registered
Theo
Joined
·
7,182 Posts
Can't view a single file.
 

·
Registered
Theo
Joined
·
7,182 Posts
Joat you need a sketch up viewer or sketch up program. I will put them as pdf files tonight.
I already have a sketch up program, but it sure doesn't work with that.
 

Attachments

·
Registered
Joined
·
198 Posts
So is there a question or something you need help with?


In woodworking there is always more then one way to accomplish something.
 

·
Registered
Theo
Joined
·
7,182 Posts
So is there a question or something you need help with?
Moving some wood and a chair into my shop is all I can come up with just now. When can I expect you?
 

·
Registered
Joined
·
1,002 Posts
Discussion Starter · #17 ·
Started build cut all the shelf frame pieces . Ready to start assembling frames. Then drill holes to attach frames to sides.
 

·
Registered
Joined
·
1,002 Posts
Discussion Starter · #18 ·
I assembled the shelf frames for the right side of desk . I am going to bolt the frames to the sides and middle supports. So middle frame support are not on yet because I'll need to drill holes first and put 5/8 inch particle board on top. The frames are 3/4 short because I'm going to put a suto face frame in front. Here is a picture of the frames.
 

Attachments

·
Registered
Joined
·
1,002 Posts
Discussion Starter · #19 ·
I got all the holes drilled in the frames. Drilled the right side holes to connect shelf frames fit good. I did make one mistake forgot to account fot 1/2 mdf top shelf will be a 1/2 short. Instead of 6 inches it will be 5 1/2 no big deal. Trimmed the frames to accommodate the 3/4 inch face frame piece. I'm going to pick up 1/2 inch mdf for on top of shelf frames.
 
1 - 20 of 23 Posts
Top