Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
23,784 Posts
Hi Dave

You will not be disappointed, it will and can do raised panels but you need to get a variable speed control device like the link below, if you want to use the standard panel bits but you can always use the vert.panel bits like the link below without the speed control if you want, but it's nice to have the speed control for other bits as well.

Just a NOTE *** it's always best to make two passes when making door panels with either types of bits,most bits don't need to turn at 24,ooo rpm.to do a nice job plus your bits will last longer and will not burn the stock at a lower speeds and it's safer.

http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=43060


Vertical Raised Panel Bits
http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/raisvert.html

Undercutter Bits
http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/raisvert.html


Bj :)
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top