Router Forums banner
1 - 2 of 2 Posts

·
Administrator
David - Machinist in wood
Joined
·
4,065 Posts
Discussion Starter · #1 ·
I don't know if this should be here in Jigs and Fixtures so please move it if there's a better spot.

In making the guitar bridges I use my spindle sander to sand the wings on each end of the bridge. But all I have are 80 and 100 grit sleeves so I was all set to order some finer grit sleeves when it crossed my mind that I should just make some. I didn't check to see if there are dozens of 'how-to' videos on this but rather decided to just use what I had on hand and go for it.

Here are the completed sleeves yet to be unwrapped -
Shoe Ceramic


And the complete video on making these sleeves -

Enjoy!
David
 

·
Administrator
David - Machinist in wood
Joined
·
4,065 Posts
Discussion Starter · #7 ·
Okay now that you have the prototypes perfected and have figured out how to mass produce them where do we place our orders and do forum members get a discount?:jester:
Oops!

Tell you what, Mike, just send your piece to be sanded, along with a prepaid return label, and I'll sand it for you. Is that a good compromise? :nerd::wink:

David
 
1 - 2 of 2 Posts
Top