Router Forums banner
1 - 1 of 11 Posts

· Registered
387 Posts
Hi, Sherwood: The guide you should use is the one specified for your jig. With the guide and bit mounted you should have clearance between the bit and guide for chip removal. If you use a plunge router be careful not to release the plunge mechanism and cause the bit to come up to the guide. Usually, the instructions for the guide include a rough setting point for the distance the bit should extend downward below
the template fingers. Making test joints would the tell you if the bit is to low or to high... Hope this helps .. Woodnut65
1 - 1 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.