Router Forums banner
1 - 1 of 3 Posts

· Registered
24 Posts
Discussion Starter · #1 ·
Hey gang,

I am having trouble getting the depth of my pins and tails to match. I'm also having trouble with my terminology here. Are the pins the male part of the joint or the female part? Anyway, when I dryfit the joint the male part is too long and keeps the shoulders next to it from fitting tightly against the shoulders next to the female part of the joint. This allows some wiggling and slop in the joint. I thought the whole secret here was not to adjust the height of the bit between cutting the pins and tails. What am I doing wrong?

1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.