Router Forums banner
1 - 1 of 3 Posts

· Registered
1,702 Posts
Gee I hope I get this right..... I think when I learned about this years ago they said that the fronts/backs are pin pieces and sides are tail pieces.....

You are correct in that the height should not be reset but you have to have it right before that is true. So if I'm reading you right the depth of cut is too deep so you need to reset the depth to a lesser amount and try again.

1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.