Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Is it possible to dovetail a board that is over 6' long while laying flat on a bench with a General Tools dovetail jig? I am building a workbench that I want to use 3/4" Poplar around the outside edges. The core of the bench is 4 pieces of 3/4" plywood that has been laminated together. I want to use this jig with my handheld Porter Cable router.The bench is just over 6' long by 24" wide.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top