[Glenmore]

I could not believe the prices on these. I started building my own yesterday and went on line last night for some ideas. And found some places are asking over a 100.00 and more for a simple project. I'm building mine out of 1x6 pine used some 1/4 ply with just drilling holes in it randomly. I intend to build mine 32" L x 24" W that should take a lot of sanding dust into the vacuum.

 

[Glenmore]

well I have it finished the only problem I've found with it is not enogh suction. Might have to go with the bigger hose. Unless maybe should I put a bottom onto it. It might have been a mistake to just set on the bench Stan and Jim-Iowa what do you think.

Daryl I have the camera but not the time to figure it out. Can't get it from the mrs's she has her toys and I have mine and the camera is one of them.

 

[Glenmore]

Stan I think your right I'll put my shop vac air purifier down on my work bench next time I'm sanding to see if that helps. Thanks

 

[Glenmore]

Guys got my first shop notes today and they have one to build. I 'm going to cut down the sides from 6" to 1 1/2" and put a bottom on it so it will be less volume for the suction. Yes and I used a 1/2" bit for the holes. Thanks for the info guys. I'll try this and tell you how I make out.

 

[Glenmore]

Good idea I have some flashing thanks I'll line the bottom with that.