Router Forums banner
1 - 1 of 7 Posts

· Registered
Joined
·
387 Posts
Hi T Slot: It looks like the drawer fronts were made with a drawer finger pull bit, and a V groove bit. The finger pull bit seems to have been putin at an angle. It is possible to cut an angled piece of wood on a table saw and use it fastened to the router table
so that your work will be cut at that angle.
Woodnu65
 
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top