[reible]

Hi,

I think GoonMan is right about the finger pull but from the shape of the cut it looks like it came in on an angle.... that might be tricky to reproduce.

The cut above it lookis like a radius groving bit/plunge roundover bit.

It sounds like the first order of business is to make a sign to hang over the shop door so it don't get confused with a garage..... No car has seen the inside of my garage.... I mean shop since 1996.......

Ed

 

[reible]

Tom is right.... I think..... Draw pulls are done with the piece vertical at about a 12-15 deg back angle. But if one had a router that could be tilted it could be done that way too. I tried to see the two pieces yesterday but I didn't see it... Tom has better eyes then I do.

Ed