Router Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1,569 Posts
Discussion Starter #1
I ran across this jig that Serge made for drilling holes in small round parts, like slices of dowels, etc. The third picture down the page shows it in use, and there is a link right there that says "my homemade light drill press jig" that will take you to the build of it.

I can think of a few times when this would have made things a lot easier and safer.
https://atelierdubricoleur.wordpres...per-feet-patins-protecteurs-souples-gratuits/
 

·
Registered
Joined
·
1,151 Posts
Yes, that's quite a tidy little setup. Should be adaptable to a variety of shapes as well.

I recently needed to drill holes in some triangular shaped pieces of wood, and made up a wedge shaped jig attached to my drill press table for the purpose. Not as fancy as this setup though.

Thanks for posting.
 

·
Registered
Joined
·
4,625 Posts
Nice jig...very useful...thanks for sharing...
 

·
Registered
Joined
·
2,603 Posts
Great idea and this is something I can use. You would think I could come up with idea every once in a while.
 
1 - 4 of 4 Posts
Top