Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Mike I don't think they ever intended for that router to be used in a table because of its small size. The router table has an opening large enough so that you could use a panel raising bit in it which won't chuck in your router. Bottom line is that they really aren't that compatible. You could mount a plate to the router and then bolt that to the table plate but that will impact your depth of cut which is already a bit limited. That appears to be the same as our DW 611 model sold here. Good little trim router and I own that kit.
This router is marked as fully compatible with that table with a big green tick. I too am finding it difficult to understand how I am meant to attach it
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top