Router Forums banner
1 - 2 of 2 Posts

·
Retired Moderator
Joined
·
16,385 Posts
Mike I don't think they ever intended for that router to be used in a table because of its small size. The router table has an opening large enough so that you could use a panel raising bit in it which won't chuck in your router. Bottom line is that they really aren't that compatible. You could mount a plate to the router and then bolt that to the table plate but that will impact your depth of cut which is already a bit limited. That appears to be the same as our DW 611 model sold here. Good little trim router and I own that kit.
 

·
Retired Moderator
Joined
·
16,385 Posts
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top