Hi Guys! In need of some info or better yet advise by experience:
I recently bought one of the Triton routers with the micro-adjust for table mounting. Everything was going fine until I discovered the crank raises the router about 0.071"/ rev. of the crank. I didn't do the math to see if that's a metric standard, but the increments on the adjusting tube wheel don't correspond to inches and fractions. I've decided to mount a DRO display outside the dust box but the motor doesn't have any easy mounting locations for the scale or transducer.
Could someone help me get this DRO mounted to the motor? A picture or two would be great!
Thanks for all the help and words of encouragement!