Router Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
367 Posts
Amen to that Bob3. As one who has only recently started to use drum sander in my drill press, at about 750 RPM, I can't imagine what would happen if you hit the GO button on your router and started one of them spinning at 20,000 RPM! Might not be much fun!
One of those really good ideas that must be left on the drawing room floor.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top