[difalkner]

Y'all both did better than me; I made a 'temporary' dust shoe right after I built the CNC figuring I would come back later and build a high tech masterpiece. Well, the temporary dust shoe is still working just fine so I guess it's not so temporary 'cause it's been working for the last five years. It's made with 1/2" MDF, a $5 broom from Lowe's, and a piece of a carpet runner - truly an exceptional build!

The top side says "No dust" and the bottom side says "Dust" because that's just the way my humor works.

 

[difalkner]

2. My biggest issue is the single 4" port. when Im cutting near the Y0 area it hangs past the end of the table and does very little dust collecting so it ends up all over the floor.

Mine has that issue, as well, so I do my best not to cut that close to the end where that can happen. Sometimes it's unavoidable, though.

You have a very stout and strong looking bracket, pretty sharp.