Router Forums banner

Dust collection for router table

2987 Views 2 Replies 3 Participants Last post by  wayne-m-peterson
I am putting the finishing touches on my router table and have a dust collector for above the top made in to the fence. I also want to collect chips, dust from inside the cabinet. Ideally, I would like to use a "Y" type connector so I could get both the top and inside using a 4" hose from my DC. Any help in aquiring the required connectors, etc would be appreciated. :D
1 - 3 of 3 Posts
I did the same thing. The parts you need are also available from Rockler. Setting up the Y connector with dual blast gates worked well. Turned out I could open / close the manual gates partially to balance the suction (into the fence, down into the cabinet) very well.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top