Router Forums banner

Dust collector stop/go remote switch

11K views 36 replies 17 participants last post by  harrysin 
The HF dust collector I have is connected to the table saw, and a second blast gate is available so I can hook up a hose to the other tools when they are being used (jointer, planer, drum sander).

I used one of those cheap remotes for awhile and it lasted for several months , then quit working. Since it came in a three pack, I switched to another one. Same deal.

Then I ran an extension cord to a box adjacent to the blast gate and manually turned the DC on and off.

The last change was to purchase a Long Ranger. Problem solved. The extension cord/switch now controls the air compressor so I can turn it on/off only when air tools will be used.

The remote wasn't cheap, but it works on the higher demand of amps during startup.
https://www.amazon.com/PSI-Woodworking-LR110-3-110-Volt-Collector/dp/B00004S9AI

Note: Amazon says I purchased it in May 2017 so it's been a year of trouble free use.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top