Router Forums banner


912 Views 4 Replies 5 Participants Last post by  mgmine
Hi I've just renewed the bearings on my Router and all went well getting the wires back into place was a bit of a job! Feeling pleased with myself I plugged it in and nothing !! Not so pleased now! short of hitting it with a hammer, I know all the spade terminals are in the right place as I took loads of pictures and checked all the usual suspects. Does anybody have any sensible suggestions please.
1 - 5 of 5 Posts
There must be a loose connection somewhere. Did you check the breaker your plugged into?
Welcome to the forum, Pappion...
Welcome to the forum @Pappion
Not wanting to reinvent the wheel I would suggest that you go to Youtube and watch a few videos on trouble shooting a power tool. Since it was working before you opened it up you may have a broken wire either inside the insulation or at the spade terminal. It should be easy to find with a meter.
  • Like
Reactions: 1
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.