Router Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,663 Posts
I assume by wavey you mean it's been intentionaly cut with some type of wavey edge in one direction and you're wanting to put a roundover, cove or ogee type edge along that wave - In the table I'd remove my fence, and use a bit with a top bearing to follow that edge - if you're trying to roundover the full thickness of the piece, then I'd make a template that exactly duplicates that edge, double sided tape it on top and let the bearing follow that. Practice on some scrap first to get the feel of it if you've never done this before.
 

·
Registered
Joined
·
335 Posts
Catch Bob and Rick on their PBS show or try the link to the Woodworking Channel found at this site. You will learn almost immediately watching Bob. He is the king of using jigs or patterns. That will make Gilbear's reply crystal clear. -Derek
 
1 - 3 of 3 Posts
Top