Router Forums banner
1 - 20 of 27 Posts

·
Registered
Joined
·
669 Posts
Discussion Starter · #1 ·
I used the Aspire to design this elk, but only to make profile cutouts to glue up for hand carving. I also used aspire to create correctly scaled profile cuts for the antlers. They were carved out of PVC, carved, than heated and formed to the correct shape.


DId about the same thing with the Buffalo carousel piece but did use the cnc to carve on side of the buffalo.
 

Attachments

·
Registered
Joined
·
31,264 Posts
whew!!!!
 
  • Like
Reactions: Scottart

·
Super Moderator
John
Joined
·
6,962 Posts
Amazing work love
 
  • Like
Reactions: Scottart

·
Registered
Joined
·
669 Posts
Discussion Starter · #16 ·
Ugly

it is a Mushroom fairy in the back ground. no cnc work there. just chainsaw

The Elk is 24" wide, 15" deep and 30" tall.

the BUffalo is about 12 x 12"
 

Attachments

·
Registered
Rick
Joined
·
17,578 Posts
Scott, I suspect you have some kind of high functioning savant skills going on there :)

Unfortunately for me , I’m an Idiot Savant , minus the savant part :|
 

·
Registered
Joined
·
669 Posts
Discussion Starter · #20 ·
YOU TWO are hilarious... I will how ever check with the wife unit again to see if I am some kind of Genius or savant. I doubt that I can post her answer..
 
1 - 20 of 27 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top