Router Forums banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·

Still use my old Elu 177EMOF/2 router (portable use) and am keen to get some form of dust extraction in place. Looking at the part's lists available the only 177 to have a dust extraction fitting(s) was from the Mark 4 through to the DeWalt 625 routers.

I have tried the latest DeWalt fitting which doesn't fit, primarily because the holes for the securing screws do not line up on the router base.

Has anyone found a suitable part or successfully managed to adapt one?

Any help appreciated. Many thanks
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.