Router Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
The people who designed the Erbaur router tool packaging must be completely DEMENTED!. After cutting the plastic packaging off with a sharp knife, the router bit is then set in a square plastic box. Can't get it out even with a hammer. DEMENTED!!!!
 

·
Registered
Joined
·
2,032 Posts
If it's anything like the bits that Micro Jig sells you need to cut the label and twist the container top then pull up. BTW, welcome to the forum!
 

·
Official Greeter
Ross
Joined
·
10,050 Posts
Welcome to the forum.
 
1 - 4 of 4 Posts
Top