Router Forums banner
1 - 1 of 1 Posts

·
Banned
Joined
·
12,004 Posts
Is your fence a one or two piece design? As long as the fence surface is on the same plane it does not need to be parralel to the table. The round bit will be exposed the same amount from any angle as long as both sides of the fence line up. You can use any straight edge to align a two piece fence. If you are using a miter slot in your table with the fence you will need to measure both ends from the slot edge to the fence. If you are using the miter slot alone with a sled this is not needed.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top