[D.R.ArmsrongSr.]

Where does one find the material to make the fences & slides that Bob & Rick use on thier table top with there router? Since some are differant than outhers, there must be a viable source for the material to make them from. Just curious.DRA

 

[ejant]

Try Ebay, do searches on High Density Poly Ethelene or UHMW

 

[AKROPAUL]

I know Lee Valley carried UHMW plastics at one time.Not sure if they still do.

 

[JohnH]

You can also find it here.http://shop.woodcraft.com/Woodcraft...alse&mscssid=06483C0C7B3A44B4D809481FD84EB0A0

 

[UsaHog]

Hello, New here but have been viewing some of the posts... this one caught my eye as I just posted to a thread on woodnets forums about router jig material this afternoon... 10/19/04, I will copy and paste it here for others to possibly use...

http://www.forums.woodnet.net/ubbth...&Number=1178801&page=2&view=collapsed&sb=5&o=

the website for this material is http://www.admiralcraft.com/ page 65 these are commercially used cutting board material but have worked very well for me for making Jigs and router plates...

I'll post some pictures when I can

Nice to meet you all

Hog